•If you select BOOTP=NO→, the printer is configured to accept TCP/IP parameters from the control panel. Continue with step 4.

4.If you selected BOOTP=NO→, press ↑ to configure each TCP/IP parameter. For example, to configure the IP address:

a.Press ↑ until IP BYTE=0 is displayed. Press [Enter].

b.Press ↑ or ↓ to select the number (0-255) for that byte, then press [Enter].

c.Press ↑ to select the next byte.

d.Continue the same process until all bytes are entered.

Note that a valid IP address is required for proper operation.

5.If appropriate, configure the subnet mask bytes (SM), syslog server IP address (LG), default gateway (GW), and timeout (TIMEOUT) in the same manner.

The TIMEOUT parameter default is 90 seconds. Up to 3600 seconds can be configured. If set to “0”, the timeout feature of the HP JetDirect card is disabled—TCP/IP connections remain open until closed by the server.

6.To save the configuration, press the ↑ and ↓ keys simultaneously. A configuration page will print. Your configuration is now active.

7.Press [Previous] until the STATUS Ready is displayed.

To manually configure other parameters, see the appropriate sections in this chapter.

To complete the print server configuration, see the HP JetDirect software installation guide included with the product.

4-12 Control Panel for Large-Format Printers