Chapter 12

HP All-in-One not found

Solution: If the product is not properly connected to the computer, communication errors can occur Make sure the USB cable is securely connected to the product and the computer, as shown below.

Troubleshooting

For more information, see:

After setting up the product, it does not print

Cause: This error applies only to USB-connected devices. The USB cable was not plugged in properly.

Communication test failed

Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved.

Solution 1: Make sure the product is turned on

Solution 2: Make sure the product is connected to the computer

Solution 1: Make sure the product is turned on

Solution: Look at the On button located on the product. If it is not lit, the product is turned off. Make sure the power cord is firmly connected to the product and plugged into a power outlet. Press the On button to turn on the product.

Cause: The product was turned off.

If this did not solve the issue, try the next solution.

180 Troubleshooting

Page 183
Image 183
HP F2200 manual HP All-in-One not found, Communication test failed, Solution 1 Make sure the product is turned on