HP M1120 MFP manual Clean the scanner glass, Adjust the lighter/darker contrast setting

Clean the scanner glass

Dirty glass, from fingerprints, smudges, hair, and so on, slows down performance and affects the accuracy of special features such as fit-to-page and copy.

1.Turn off the product, unplug the power cord from the electrical socket, and raise the lid.

2.Clean the glass by using a soft, lint-free cloth or sponge that has been moistened with nonabrasive glass cleaner.

CAUTION: Do not use abrasives, acetone, benzene, ammonia, ethyl alcohol, or carbon tetrachloride on any part of the product; these can damage the product. Do not place liquids directly on the glass. They might seep under it and damage the product.

3.To prevent spotting, dry the glass by using a chamois or cellulose sponge.

Adjust the lighter/darker (contrast) setting

The lighter/darker setting affects the lightness or darkness (contrast) of the copy. Use the following procedure to change the contrast for the current copy job only.

Adjust the lighter/darker setting for the current job

1.On the product control panel, press Lighter/Darker to see the current contrast setting.

2.Use the arrow buttons to adjust the setting. Move the slider to the left to make the copy lighter than the original, or move the slider to the right to make the copy darker than the original.

3.Press Start Copy to save the selection and immediately start the copy job, or press OK to save the selection without starting the job.

NOTE: The change in the setting remains active for about 2 minutes after the copy job has been completed. During this time, Custom settings appears on the product control-panel display.

Adjust the default lighter/darker setting

NOTE: The default lighter/darker setting affects all copy jobs.

1.On the product control panel, press Setup.

2.Use the arrow buttons button to select Copy setup, and then press OK.

3.Use the arrow buttons button to select Def. Light/dark, and then press OK.

ENWW Copy settings 55