3. Install the Battery

Your camera uses a rechargeable HP Photosmart R07 Lithium Ion battery (L1812A/L1812B).

1.Open the Battery/ Memory card door on the bottom of the camera by sliding the door latch as indicated on the Battery/Memory card door.

2.Insert the battery in the

larger slot as shown, and push the battery in until the latch catches.

3.Close the Battery/Memory card by pushing the door down until it snaps into place.

To remove the battery from the camera, first turn the camera off. Open the Battery/Memory card door and release the battery latch to allow the battery to be partially ejected, then pull the battery from the slot.

See page 171 for information about battery performance with this camera. For the number of shots expected for each battery based on usage, see page 172. For hints on optimizing battery performance, see Appendix A, Managing Batteries, starting on page167.

NOTE: The rechargeable battery that was shipped with your camera may be partially charged. You should fully charge it before using it the first time (see page 15).

14 HP Photosmart R817/R818 User’s Manual