5 Upgrading the Hardware

Tools and Supplies Needed

Procedures in this section require the following tools and supplies:

Jumper-removal tool or needle-nosed pliers

Small flat-bladed screwdriver

Phillips (cross-head) screwdriver (#2)

Pen or pencil

Anti-static wrist strap and conductive foam pad (recommended)

Figure 10. Tools and Supplies Needed

Equipment log: as you integrate new parts into the system, add information about them to your equipment log (Appendix B). Record the model and serial number of the system, all installed options, and any other pertinent information specific to the system.

Caution and Danger Statements

Caution and danger statements apply throughout this chapter. Only a technically qualified person should configure the server hardware.

Note

System power on/off: The power button DOES NOT switch off system power. To remove power from the system, you must unplug/disconnect the power connections. Make sure power connections are unplugged/ disconnected before you open the chassis, add, or remove any components.

61

Page 73
Image 73
IBM 343 manual Upgrading the Hardware, Tools and Supplies Needed