Processor
The server board accommodates one or two Pentium III processors up to
Memory
The system board contains six
Note
Use DIMMs that have been tested for compatibility with the server board. Contact your sales representative or dealer for a current list of approved memory modules.
PCI Riser Slots
The server board has two PCI riser slots: a 5 V riser that supports
•Bus speed up to 66 MHz
•32 bit memory addressing
•5 V/3.3 V signaling environment
•Burst transfers of up to 512 Mbps
•8, 16, 32, or
•Plug and Play ready
•Parity enabled
Video
The server board uses an ATI RAGE XL PCI graphics accelerator with 8 MB of video SDRAM that supports all standard IBM VGA modes. The embedded SVGA video subsystem supports:
•Pixel resolutions up to 1600 x 1200 under 2D and 1024 x 768 under 3D
•CRT and LCD monitors up to 100 Hz vertical refresh rate
The server board supports disabling of the onboard video through the BIOS setup menu or when a plug in video card is installed in any of the PCI slots.
SCSI Controller
The SCSI version of the server board includes an embedded Adaptec
The SCSI bus is terminated on the server board with active terminators that cannot be disabled. The onboard device must always be at one end of the bus. The device at the other end of the cable is terminated with the active terminator on the SCSI cable installed in the system.
Chassis Description | 15 |