4.Remove the two screws securing the cable retention bracket (A in Figure 13) and lift the bracket out (B in Figure 13).

5.Disconnect the hard disk drive power cable (D in Figure 13).

6.Disconnect the hard disk drive ribbon cable (C in Figure 13).

7.Remove the three securing screws (E in Figure 13), lift the hard disk drive out of the hard disk drive carrier, and place on a clean, static-free work surface.

Figure 13. Removing a Hard Disk Drive

Upgrading the Hardware

65

Page 77
Image 77
IBM 343 manual Removing a Hard Disk Drive