Features and specifications

The following table provides a summary of the features and specifications of your xSeries 450.

Microprocessor:

vIntel®™ Itanium® 2 900 MHz or higher, depending on server model

v1.5 MB (minimum) Level-3 cache

v200 MHz front-side bus (FSB), at two data transfers per cycle, yielding a 400 MHz system bus (minimum)

vSupport for up to four microprocessors

vXceL4Server Accelerator Cache: 64 MB

Active Memory:

vMinimum: 1 GB

vMaximum: 40 GB

vType: 2-way interleaved PC2100, ECC DDR SDRAM, registered DIMMs only

vSupports 512 MB, 1 GB, and 2 GB dual inline memory modules (DIMMs)

Drives standard:

DVD/CD-RW: IDE

Expansion bays:

vTwo removable media bays (one DVD/CD-RW preinstalled)

vSupports up to two internal Ultra320 SCSI hard disk drives

ActivePCI-X expansion slots:

Six 64-bit Active PCI-X expansion slots:

vTwo 66 MHz PCI-X slots

vTwo 100 MHZ PCI-X slots

vTwo 133 MHZ PCI-X slots

Cooling:

Four hot-swap fans

vTwo 150 mm x 51 mm fans

vTwo 150 mm x 38 mm fans

Acoustical noise emissions:

vDeclared sound power, idle: 6.5 bels

vDeclared sound power, operating: 6.5 bels

vBystander sound pressure, idle: 49 dBa

vBystander sound pressure, operating: 49 dBa

Power supply:

Two power supplies: 550 watts at 100-127 V ac or 1050 watts at 200-240 V ac (hot-swappable and redundant at 200-240 V ac only)

Video:

vIntegrated ATI RageXL video

vPCI bus interface

vCompatible with SVGA

v8 MB SDRAM video memory

Size (4 U):

vHeight: 17.8 cm (7 inches, 4 U)

vDepth: 69.85 cm (27.5 inches)

vWidth: 48.3 cm (19 inches)

vMaximum weight: 38.6 kg (85 lb), depending on your configuration

Integrated functions:

vBroadcom 5704 10/100/1000 dual port Ethernet controller

vLight Path Diagnostics

vOne external and one internal Ultra320 SCSI port (dual-channel integrated controller with RAID capabilities)

vRemote Supervisor Adapter (service processor)

ASM interconnect (peer-to-peer) port

Ethernet port

Serial port

vIDE controller

vRXE Management port

vRXE Expansion ports

vThree USB ports

vSCSI ports

vSerial port

vWake on LAN®

Environment:

vAir temperature:

Server on: 10° to 35°C (50.0°

to 95.0°F). Altitude: 0 to 914 m (2998.7 ft)

Server on: 10° to 32°C (50.0°

to 89.6°F). Altitude: 0 to 2133 m (6998.0 ft)

Server off: -40° to 60°C (-104° to 140°F). Maximum altitude: 2133 m (6998.0 ft)

vHumidity:

Server on: 8% to 80%

Server off: 5% to 100%

Heat output:

Approximate heat output in British thermal units (Btu) per hour

vMinimum configuration: 854 Btu (250 watts)

vMaximum configuration: 2646 Btu (775 watts)

Electrical input:

vSine-wave input (50-60 Hz) required

vInput voltage low range:

Minimum: 100 V ac

Maximum: 127 V ac

vInput voltage high range:

Minimum: 200 V ac

Maximum: 240 V ac

vInput kilovolt-amperes (kVA) approximately:

Minimum: 0.250 kVA

Maximum: 1.3 kVA

Notes:

1.Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use.

2.These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.

Chapter 1. General information 3

Page 13
Image 13
IBM 8688 manual Features and specifications