Format

config port autoneg <port/listofports/all> <enable/disable>

config port flowcontrol

Use this command to enable or disable IEEE 802.3x flow control for one or more ports.

Default disable

Format

config port flowcontrol <port/listofports/all> <enable/disable>

config port lacpmode

Use this command to enable or disable the Link Aggregation Control Protocol (LACP) on one or more ports.

Default disable

Format

config port lacpmode <port/listofports/all> <enable/disable>

config port linktrap

Use this command to enable or disable link status traps for one or more ports.

/NOTE

This command is valid only when the Link Up/Down Flag is enabled (see “config trapflags linkmode” on page 186).

Format

config port linktrap <port/listofports/all> <enable/disable>

config port physicalmode

Use this command to configure the speed and duplex mode for one or more ports. For this configuration to take effect, auto negotiation must be disabled.

Format

config port physicalmode <port/listofports/all> <1000f/100f/100h/10f/10h>

Acceptable values are:

1000f

1000BASE-T full duplex

100f

100BASE-T full duplex

100h

100BASE-T half-duplex

10f

10BASE-T full duplex

10h

10BASE-T half duplex

show port

Use this command to display port information.

Format

show port <port/listofports/all>

Port

The interface number of the physical port or LAG whose information is displayed

 

on the line.

Type

If not blank, this field indicates that this port is a special type of port. The possible

 

values are:

 

Mon Monitoring port, participating in Port Mirroring.

164

Intel® Blade Server Ethernet Switch Module IXM5414E

Page 174
Image 174
Intel IXM5414E manual Default disable Format, Acceptable values are, 164