Ping
Use this panel to have the switch transmit a Ping request to a specified IP address. This checks whether the switch can communicate with a particular IP device. Once you click the Apply button, the switch will send three pings and the results will be displayed in the Ping field, below the IP address.
The switch can be pinged from any IP workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path between the switch and the workstation.
IP Address | Enter the IP address of the station you want the switch to ping. The initial value is |
| blank. The IP address you enter is not retained across a power cycle. |
Ping | Displays the results of the ping. If a reply to the ping is not received, you will see |
| No Reply Received from IP xxx.xxx.xxx.xxx, otherwise you will see Reply |
| received from IP xxx.xxx.xxx.xxx: (send count = 3, receive count = n). |
Click the Apply button to initiate the ping.
Trap manager
The following
•Trap flags
•Trap log
Trap flags
This panel displays trap conditions. When the condition identified by an active trap is encountered by the switch, a trap message will be sent to any enabled SNMP Trap Receivers and a message will be written to the trap log. Cold and warm start traps are always enabled.
Intel® Blade Server Ethernet Switch Module IXM5414E | 89 |
