Intel IXM5414E manual Igmp snooping commands, Config igmpsnooping adminmode

Port GMRP Mode

Indicates the GMRP administrative mode for the port. It may be enabled or disabled. If this parameter is disabled, Join Time, Leave Time and LeaveAll Time have no effect. The factory default is disabled.

Port GVRP Mode

Indicates the GVRP administrative mode for the port. It may be enabled or disabled. If this parameter is disabled, Join Time, Leave Time and LeaveAll Time have no effect. The factory default is disabled.

IGMP snooping commands

config igmpsnooping adminmode

Use this command to enable or disable IGMP Snooping on the switch module.

Default disable

Format config igmpsnooping adminmode <enable/disable>

config igmpsnooping groupmembershipinterval

Use this command to configure the IGMP Group Membership Interval time on the IXM5414E switch module. The group membership interval time is the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface before deleting the interface from the entry. This value must be greater than the IGMP maximum response time value. The range is 2 to 3600 seconds.

Default	260 seconds
Format	config igmpsnooping groupmembershipinterval <2-3600>

config igmpsnooping interfacemode

Use this command to enable or disable IGMP Snooping on a selected interface. The <port/listofports/all> parameter identifies the interface(s) on which to enable or disable IGMP Snooping. If an interface which has IGMP Snooping enabled is enabled for routing or becomes a member of a LAG, IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will subsequently be re-enabled if routing is disabled, or the interface is deleted from the LAG.

Default disable

Format config igmpsnooping interfacemode <port/listofports/all> <enable/disable>

config igmpsnooping maxresponse

Use this command to configure the IGMP Maximum Response time on the IXM5414E switch module. The maximum response time is the amount of time in seconds that a switch will wait after sending a query on an interface because it did not receive a report for a particular group in that interface. This value must be less than the IGMP query interval time value. The range is 1 to 3599 seconds.

Default	10 seconds
Format	config igmpsnooping maxresponse <1-3599>

190 Intel® Blade Server Ethernet Switch Module IXM5414E