Intel IXM5414E manual Default Gateway, Network Configuration Protocol, Burned In MAC Address

IP Address The IP address of the interface.The factory default value is 10.90.90.9x, where x is determined by the number of the I/O-module bay into which you have installed the Ethernet switch module (see Table 1.“Default IP addresses based on I/O module bay numbers” on page 21).

Subnet Mask The IP subnet mask for this interface. The factory default value is 255.255.255.0.

Default Gateway

The default IP gateway address for this interface. The factory default value is 0.0.0.0.

Network Configuration Protocol

Indicates what network protocol was used on the last or current power-up cycle, if any. The configuration methods are DHCP, BootP and none. The factory default method is none. When management of the Ethernet switch module is enabled through the four external ports, the switch module will acquire its IP address from a Dynamic Host Configuration Protocol (DHCP) server when the switch module is turned on or reset.

Burned In MAC Address

The burned-in MAC address used for in-band connectivity if you choose not to configure a locally administered address.

Web Mode Specify whether the switch may be accessed from a web browser through TCP port

80.If you choose to Enable web mode you will be able to manage the switch from a web browser. The factory default is Enabled.

Java Mode Enable or Disable the java applet that displays a picture of the switch at the top right of the screen. If you run the applet you will be able to click on the picture of the switch to select configuration screens instead of using the navigation tree at the left side of the screen. The factory default is Enabled.

50 Intel® Blade Server Ethernet Switch Module IXM5414E