Intel IXM5414E manual Simple Network Management Protocol Snmp, Snmp community commands, 166

show mirroring

Use this command to display the port mirroring information for the switch module.

Format show mirroring

Port Mirroring Mode

Indicates whether the port mirroring feature is enabled or disabled.

Probe Port The port that is configured as the probe port. If this value has not been configured, ‘Not Configured’ will be displayed.

Mirrored Port

The port that is configured as the mirrored port. If this value has not been configured, ‘Not Configured’ will be displayed.

Simple Network Management Protocol (SNMP)

SNMP community commands

config snmpcommunity accessmode

Use this command to configure SNMP access to switch information for a specific community name. The access mode can be Read-only (also called public) or Read/write (also called private).

Format config snmpcommunity accessmode <readonly/readwrite> <name>

config snmpcommunity create

Use this command to add (and name) a new SNMP community. A community name associates the switch with a set of SNMP managers with a specified privileged level. The name can be up to 16 case-sensitive characters long.

Community names in the SNMP community table must be unique. If you make multiple entries using the same community name, the first entry is kept and processed and all duplicate entries are ignored.

Default	There are two default community names: Public (with Read-only access) and
	Private (with Read/write access). You can replace these default community names
	with unique identifiers for each community. The default values for the remaining
	four community names are blank.
Format	config snmpcommunity create <name>

config snmpcommunity delete

Use this command to remove a name from the SNMP community table.

Format config snmpcommunity delete <name>

config snmpcommunity ipaddr

Use this command to specify the IP address (or portion thereof) from which this device will accept SNMP packets with the associated community name. The requesting entity's IP address is ANDed with the IP mask before being compared to this IP address. Note that if the IP mask is set to 0.0.0.0, an IP address of 0.0.0.0 matches all IP addresses. The default value is “0.0.0.0”. The parameter <name> is the applicable community name, and may be up to 16 alphanumeric characters.

Default 0.0.0.0

166 Intel® Blade Server Ethernet Switch Module IXM5414E