Additional printer setup

37

To install a printer hard disk onto the ISP:

aUsing a flathead screwdriver, loosen the screws.

bRemove the screws attached to the printer hard disk mounting bracket, and then remove the bracket.

cInstall the printer hard disk onto the ISP:

1Hold the edges of the printed circuit board assembly, and then align the standoffs of the printer hard disk to the holes in the ISP.

2Press down on the printer hard disk until the standoffs are in place.

Warning—Potential Damage: Do not press on the center of the printer hard disk. Doing so may cause damage to the hard disk.

dInsert the plug of the printer hard disk interface cable into the receptacle of the ISP. Note: The plugs and receptacles are colorcoded.

Page 37
Image 37
Lexmark 34T5012 manual To install a printer hard disk onto the ISP