Section TOC

Master TOC

F-32F-32

TROUBLESHOOTING & REPAIR

STT CHOPPER BOARD TEST (CONTINUED)

Return to

Return to Section TOC

Return to Section TOC

Return to

Return to Master TOC

Return to Master TOC

4.Carefully apply input power to the Power Wave 455/R.

WARNING

ELECTRIC SHOCK can kill.

High voltage is present when input power is applied to the machine.

For steps 5 and 6, see Figure F.10.

5.Turn on the Power Wave 455/R. Measure the voltage from Power Board plug J43 lead 345 pin 7 (+) to lead 346 pin 1 (-). The volt- age should be approximately 20 VDC. If not correct, the Power Board may be faulty.

6.Measure the voltage from Control Board plug J7 lead 4W pin 13 (-) to lead 4R pin 14

(+). The voltage should be 4 – 5 VDC. This is the pulse width modulation signal to the STT Chopper Board. If not correct, the Control Board may be faulty.

7.When the test is completed, remove input power from the Power Wave 455/R.

8.Install the case top using the 3/8” nut driver.

Return to Section TOC

Return to Master TOC

POWER WAVE 455/R

Page 78
Image 78
Lincoln Electric SVM156-A service manual 32F-32