
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
|
| TROUBLESHOOTING & REPAIR |
INPUT CONTACTOR REMOVAL AND REPLACEMENT (CONTINUED)
FIGURE F.19 – INPUT CONTACTOR REMOVAL AND REPLACEMENT
INPUT
CONTACTOR
601
X4
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
REMOVAL PROCEDURE
1.Remove input power to the Power Wave 455/R.
2.Using the 3/8” nut driver, remove the case top, sides, and input access panel.
3.Perform the Capacitor Discharge proce- dure
4.Locate the input contactor. Label and, using the phillips head screwdriver, careful- ly remove the leads from the input contac- tor terminals. Note placement for reassem- bly. See Figure F.19.
5.With the 5/16” nut driver, remove the three mounting screws. See Figure F.19.
6.Carefully remove the input contactor.
REPLACEMENT PROCEDURE
1.Mount the contactor and tighten the mount- ing screws.
2.Assemble the leads to the correct terminals. See Figure F.18.
3.Install the case top, sides, and input access panel using the 3/8” nut driver.