
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
|
| TROUBLESHOOTING & REPAIR |
CONTROL, FEED HEAD, OR VOLTAGE SENSE PC BOARD
REMOVAL AND REPLACEMENT (CONTINUED)
3.Secure the rear of the control box in place using two screws and the 3/8” nut driver.
4.Press the Voltage Sense Board onto its standoffs. Make sure the board snaps into place on all three standoffs.
5.Connect the two molex plugs to the Voltage Sense Board.
6.Install the PC board compartment cover using the 3/8” nut driver.
7.Install the case top and sides using the 3/8” nut driver.