Return to Section TOC
Return to Section TOC
TOC
Return to Master TOC
Return to Master TOC
TOC
|
| TROUBLESHOOTING & REPAIR |
POWER BOARD TEST (CONTINUED)
FIGURE F.8 – POWER BOARD TEST
J42 | J41 | J43 |
1 | 2 | 3 | 1 | 2 | 1 | 2 | 3 | 4 | 5 | 6 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4 | 5 | 6 | 3 | 4 | 7 | 8 | 9 10 11 12 |
| J42 |
| J41 |
|
| J43 | |
TEST PROCEDURE
Return to Section
Return to Master
1.Remove input power to the Power Wave 455/R.
2.Using the 3/8” nut driver, remove the case top.
3.Perform the Capacitor Discharge Procedure.
4.Locate the Power Board and plugs J42 and J43. Do not remove plugs or leads from the Power Board. Refer to Figure F.8.
5.Carefully apply input power to the Power Wave 455/R.
6.Turn on the Power Wave 455/R. Carefully test for the correct voltages at the Power Board according to Table F.4.
7.If either of the 40 VDC voltages is low or not present at plug J41, perform the DC Bus PC Board Test. See the Wiring Diagram. Also perform the T1 Auxiliary Transformer Test.
8.If any of the DC voltages are low or not pre- sent at plugs J42 and/or 43, the Power Board may be faulty.
9.Install the case top using the 3/8” nut driver.
Return to Section TOC
Return to Master TOC
WARNING
ELECTRIC SHOCK can kill.
High voltage is present when input power is applied to the machine.
