GS716Tv2 and GS724Tv3 Software Administration Manual
4.Click the box below each port to include in the LAG. The following figure shows an example of how to configure LAG1 with ports
5.Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch.
6.If you make any changes to this page, click Apply to send the updated configuration to the switch. Configuration changes take effect immediately.
7.To view the ports that are members of the selected LAG, click Current Members.
LACP Configuration
To display the LACP Configuration page, click Switching > LAG > Advanced > LACP
Configuration.
To configure LACP:
1.From the LACP System Priority field, specify the device’s link aggregation priority relative to the devices at the other ends of the links on which link aggregation is enabled. A higher value indicates a lower priority. You can change the value of the parameter globally by specifying a priority from
2.Click Refresh to reload the page and display the most current information.
Chapter 3: Configuring Switching Information 77
