GS716Tv2 and GS724Tv3 Software Administration Manual
1.From the Querier Admin Mode field, enable or disable the administrative mode for IGMP Snooping Querier.
2.In the Snooping Querier Address field, specify the IP address to be used as source address in periodic IGMP queries. This address is used when no address is configured on the VLAN on which the query is being sent.
3.In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP queries.
4.In the Query Interval field, specify the time interval in seconds between periodic queries sent by the snooping querier. The Query Interval must be a value in the range of
5.In the Querier Expiry Interval field, specify the time interval in seconds after which the last querier information is removed. The Querier Expiry Interval must be a value in the range of
6.Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch.
7.Click Apply to apply the new settings to the switch. Configuration changes take effect immediately
8.Click Refresh to update the page with the latest information from the switch.
IGMP Snooping Querier VLAN Configuration
Use this page to configure IGMP queriers for use with VLANs on the network.
To access this page, click Switching > Multicast > IGMP Snooping Querier > Querier VLAN Configuration.
To configure Querier VLAN settings:
1.To create a new VLAN ID for IGMP Snooping, select New Entry from the VLAN ID field and complete the following fields:
•VLAN ID. Specifies the VLAN ID for which the IGMP Snooping Querier is to be enabled.
•Querier Election Participate Mode. Enable or disable Querier Participate Mode.
120 Chapter 3: Configuring Switching Information
