NETGEAR GS724TS-100NAS manual Traceroute

GS716Tv2 and GS724Tv3 Software Administration Manual

•If successful, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, Rx = x Min/Max/Avg RTT = x/x/x msec.”

•If a reply to the ping is not received, you will see “Reply From IP/Host: Destination Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”.

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.

To display this page, click Maintenance > Troubleshooting > Traceroute.

To configure the Traceroute settings and send probe packets to discover the route to a host on the network:

1.In the Hostname/IP Address field, specify the IP address or the hostname of the station you want the switch to ping. The initial value is blank. This information is not retained across a power cycle.

2.Optionally, configure the following settings:

•Probes Per Hop. Specify the number of times each hop should be probed. The valid range is 1–10.

•MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid range is 1–255.

•InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range is 0– 255.

238 Chapter 7: Maintenance