#1513 Bad attribute position in file record

This error can often be resolved by running CHKDSK /F on the affected disk. For instructions on running CHKDSK, see Symantec Solution How to Run Microsoft CHKDSK from the Command Line.

If running CHKDSK /F does not help, please send the following items to Norton Technical Support:

A debug report. See Symantec Solution Running a Debug Report.

A PARTINFO report. See “Generating Diagnostic Reports with PartitionInfo” on page 115.

The information outlined in Symantec Solution Information Needed for a Trouble Report.

If possible, an image of the machine or the actual hard disk, so Norton developers can examine the source of the issue more closely.

#1516 Partition improperly dismounted

The partition dirty flag is set in a restart record in the journal file. This error may have been caused by a power failure or system crash while the Windows NT operating system was writing the partition.

This problem can often be resolved by running CHKDSK /F on the affected drive. For instructions on running CHKDSK, see Symantec Solution How to Run Microsoft CHKDSK from the Command Line.

If running CHKDSK /F does not help, please send the following items to Norton Technical Support:

A debug report. See Symantec Solution Running a Debug Report.

A PARTINFO report. See “Generating Diagnostic Reports with PartitionInfo” on page 115.

The information outlined in Symantec Solution Information Needed for a Trouble Report.

If possible, an image of the machine or the actual hard disk so Norton developers can examine the source of the issue more closely.

#1527 Bad update sequence number

A buffer contains mismatched update sequence numbers. This error may have been caused by a power failure or system crash while the Windows NT operating system was writing to the partition. Reboot Windows NT Workstation and execute CHKDSK /F to repair the damage.

130Appendix B: Troubleshooting

Page 140
Image 140
Norton Abrasives 8 manual #1513 Bad attribute position in file record