3.3 PT Programming
SMDR RS-232C Parameter [800]
|
| <Select the new line code> | <Select the baud rate> | |||
8 0 | 0 | NEXT | SELECT | STORE | NEXT SELECT STORE | |
|
|
| (CR+LF/CR) |
| (1200/2400/ | |
|
| CR: Carriage Return |
| 4800/9600 B) | ||
|
| LF: Line Feed |
|
|
| |
<Select the word length> | <Select the parity bit> | <Select the stop bit length> | ||||
NEXT | SELECT | STORE | NEXT | SELECT STORE | NEXT SELECT STORE END | |
| (7/8 bits) |
| (Mark/Space/ |
| (1 bit/2 bits) | |
|
|
| Even/Odd/ |
|
| |
|
|
|
| None*) |
|
|
Notes
•* Select "None" when the printer does not require error checking.
•The following combinations are invalid.
Parity | Word length | Stop bit length |
|
|
|
Mark | 8 | 2 |
|
|
|
Space | 8 | 1 |
|
|
|
Space | 8 | 2 |
|
|
|
If any of the above invalid combinations are selected, an alarm tone will be heard.
Feature & Programming References
1.20.1 Station Message Detail Recording (SMDR)
SMDR Parameter [801]
<Select the page length>
8 0 | 1 | NEXT | page length | STORE | |
(4…99 lines) | |||||
|
|
|
| ||
<Select the skip perforation> |
| ||||
NEXT | skip perforation | STORE END | |||
| (0…95 lines) |
|
|
Feature & Programming References
1.20.1 Station Message Detail Recording (SMDR)
Incoming/Outgoing Call Selection for Printing [802]
| <Select an outgoing call> | <Select an incoming call> |
|
8 0 2 | NEXT SELECT STORE | NEXT SELECT STORE | END |
| (On/Off/Toll) | (On/Off) |
|
252
Feature Guide