Panasonic kx-tea308 Feature Guide References, User Manual References, Mode, Hold-2, Hold-3

		1.12 Holding Features
Mode	Hold	Transfer to Extension
	Pressing the Recall/hookswitch	Pressing the Recall/hookswitch
	+	+
Hold-2	Call Hold Feature No.	Extension No.
	+
	Going on-hook
	Pressing the Recall/hookswitch	Pressing the Recall/hookswitch
	+	+
Hold-3	Call Hold Feature No.	Call Hold Feature No.
	+	+
	Going on-hook	Extension No.

In some cases, a call is not disconnected when an SLT user goes on-hook. Instead, the call is mistakenly placed on hold. After a specified time expires, the Hold Recall tone is heard. When the SLT user answers this, the user hears a cyclic tone (like a reorder tone). To avoid this problem, select "Hold- 2" or "Hold-3". In either of these modes, all calls are disconnected when going on-hook, unless the Call Hold feature number is entered after pressing the Recall/hookswitch.

It is possible to set each SLT not to receive pulse signals through system programming ( Internal Pulse Detection [614]). This setting helps the PBX to avoid mistaking pulse signals sent by dialling "1" for hooking, in the countries/areas where the length of time that the Recall/hookswitch is pressed is set to "MODE 1: 50–180 ms" in Hookswitch Flash Timing Range [207].

Feature Guide References

4.2.1 Tones/Ring Tones

User Manual References

1.4.2 Holding a Call

Feature Guide

91