Paradyne 7112 Dsx1B8ZS2 ± Indicates, Dsx1AMI5 ± Indicates, Dsx1SendNoCode1 ±, Dsx1SendLineCode2 ±

MIB Descriptions

Table C-7. DS1 Near End Group Configuration Table Objects (2 of 4)

Object, OID, Access	Description	Setting/Contents
dsx1LineCoding	Corresponds to the network	Supports the following
(dsx1ConfigEntry 6)	line coding configuration	values:
1.3.6.1.2.1.1.10.18.6.1.6	option for the network	H dsx1B8ZS(2) ± Indicates
	interface on the DSU/CSU.
read-write		B8ZS line coding.
		H dsx1AMI(5) ± Indicates
		AMI line coding.
dsx1SendCode	Indicates the test	Supports the following
(dsx1ConfigEntry 7)	patterns/codes being sent	values:
1.3.6.1.2.1.1.10.18.6.1.7	over the network interface.	H dsx1SendNoCode(1) ±
read-write		specifies that the interface
		is sending normal or
		looped data. Setting the
		interface to this value
		stops an active ªsend
		patternº test on the
		interface.
		H dsx1SendLineCode(2) ±
		specifies that the network
		interface is sending a
		Remote Loopback UP
		code for 10 seconds.
		H dsx1SendResetCode(4) ±
		specifies that the network
		interface is sending a
		Remote Loopback DOWN
		code for 10 seconds.
		H dsx1SendQRS(5) ±
		specifies that the network
		interface is sending a
		QRSS test pattern. The
		pattern is sent until the test
		is halted (i.e., setting to
		dsx1SendNoCode).
		H dsx1SendOtherTestPatte
		rn(8) ± specifies that the
		network interface is
		sending a 1-in-8 test
		pattern. The pattern is sent
		until the test is halted (i.e.,
		setting to
		dsx1SendNoCode).
dsx1CircuitIdentifier	Contains the transmission	A string of 0 to
(dsx1ConfigEntry 8)	vendor's circuit identifier,	255 characters.
1.3.6.1.2.1.1.10.18.6.1.8	for the purpose of
	facilitating troubleshooting.
read-write
	Applies to the T1 network
	interface only.

C-14 March 1998 7112-A2-GB20-10