Paradyne 7112 manual Input Signal Table Objects, Rs232InSigEntry

MIB Descriptions

Table C-13. Synchronous Port Table Objects (2 of 2)

Object, OID, Access	Description	Setting/Contents
rs232SyncPortMode	Specifies the port's mode of	Supports only the following
(rs232SyncPortEntry 12)	data transfer.	value:
1.3.6.1.2.1.10.33.4.1.12		fdx(1) ± Full-duplex
read-write
rs232SyncPortMinFlags	Specifies the minimum	The only valid value is 2.
(rs232SyncPortEntry 14)	number of flag patterns the
1.3.6.1.2.1.10.33.4.1.14	port needs in order to
	recognize the end of one
read-write
	from and the start of
	another.

The following is not supported:

Hrs232SyncPortIdle Pattern (rs232SyncPortEntry 13)

Input Signal Table Objects

The Input Signal Table Objects contains entries for the input signals that can be detected by the unit for the synchronous user data port. Clarification for objects contained in this table as it applies to the unit is provided below.

Table C-14. Input Signal Table Objects

Object, OID, Access	Description	Setting/Contents
rs232InSigName	Contains the identification	Supports only the following
(rs232InSigEntry 2)	of a hardware input signal.	values:
1.3.6.1.2.1.10.33.5.1.2		rts(1) ± Request To Send
read-only		dtr(4) ± Data Terminal Ready
rs232InSigState	Contains the current signal	Supports only the following
(rs232InSigEntry 3)	state.	values:
1.3.6.1.2.1.10.33.5.1.3		on(2) ± The signal is asserted.
read-only		off(3) ± The signal is
		deasserted.
rs232InSigChanges	Indicates the number of	The object is incremented
(rs232InSigEntry 4)	times that a signal has	each time that the signal is
1.3.6.1.2.1.10.33.5.1.4	changed from on to off, or	sampled (every 100 ms) and
	off to on.	the signal state is different
read-only
		from the previous state.

C-24 March 1998 7112-A2-GB20-10