Paradyne 7112 manual Rear Panel Interface Connections, Snmp Management Capabilities, Network

About the T1 DSU/CSU

Rear Panel Interface Connections

Figure 1-4shows the physical interfaces of the DSU/CSU. Information about the installation of the DSU/CSU is contained in Model 7112 T1 DSU/CSU with Internal Ethernet LAN Adapter Startup Instructions.

10BaseT

TERMINAL

POWER

NETWORK

D

T

E

or

Terminal

Ethernet

Modem

DTE

T1

Network

97-15694

Figure 1-4. Rear Panel Connectors

CAUTION:

The 10BaseT and Network connectors are not keyed. Follow the installation procedures carefully to avoid connection errors.

SNMP Management Capabilities

The DSU/CSU supports SNMP Version 1, and has the capability of being managed by any industry-standard SNMP manager and accessed using SNMP protocol by external SNMP managers.

Management Information Base (MIB) Support

The following MIBs are supported:

HMIB II (RFC 1213 and RFC 1573) ± Defines the general objects for use with a network management protocol in TCP/IP internets and provides general information about the DSU/CSU. MIB II is backward-compatible with MIB I.

HEthernet-like MIB (RFC 1643) ± Defines objects for managing Ethernet-like interfaces (e.g., 10BaseT).

HRS-232-Like MIB (RFC 1659) ± Defines objects for managing RS-232-type interfaces and supports the V.35 synchronous data port on the DSU/CSU.

HEnterprise MIB ± Supports configuration, status, statistics, and tests on the DS1 network interface.

HDS1/E1 MIB (RFC1406) ± Defines objects for managing DS1 interfaces and supports the network interface on the DSU/CSU. DS1 Near End Group and DS1 Fractional Group are supported.

HGeneric-Interface Extension MIB (RFC 1229) (Generic Interface Test table only) ± Provides extensions to the generic interface group defined in

MIB II.

1-4 March 1998 7112-A2-GB20-20