Paradyne 7112 manual Dsx1NoLoop1 ± The T1, Dsx1PayloadLoop2 ±, Dsx1LineLoop3 ±, Dsx1OtherLoop4 ±

MIB Descriptions

Table C-7. DS1 Near End Group Configuration Table Objects (3 of 4)

Object, OID, Access	Description	Setting/Contents
dsx1LoopbackConfig	This object specifies the	Supports the following
(dsx1ConfigEntry 9)	loopback state of the	values:
1.3.6.1.2.1.1.10.18.6.1.9	network interface.	H dsx1NoLoop(1) ± The T1
read-write	Applies to the T1 network	interface is not in a
	interface only.	loopback state.
		H dsx1PayloadLoop(2) ±
		Specifies that a Payload
		Loopback (PLB) is active
		for the network interface.
		H dsx1LineLoop(3) ±
		Specifies that a Line
		Loopback (LLB) is active
		for the network interface.
		H dsx1OtherLoop(4) ±
		Specifies that an
		unspecified type of
		loopback is active for the
		network interface.
dsx1LineStatus	This object specifies the	More than one value may be
(dsx1ConfigEntry 10)	line (alarm) status of the	active at a time.
1.3.6.1.2.1.1.10.18.6.1.10	network interface.	Supports the following
read-only		values:
		H dsx1NoAlarm(1) ± No
		alarm present.
		H dsx1RcvFarEndLOF(2) ±
		A yellow alarm signal is
		being received.
		H dsx1RcvAIS(8) ± An
		Alarm Indication Signal
		(AIS) is being received.
		H dsx1LossOfFrame(32) ±
		An Out Of Frame condition
		has persisted for more
		than
		2.5 seconds (i.e., Red
		Alarm).
		H dsx1LossOfSignal(64) ±
		A Loss of Signal condition
		has persisted for more
		than
		2.5 seconds (i.e., Red
		Alarm).
		H dsx1LoopbackState(128)
		± The near end of the
		network interface is in a
		loopback state.
		H dsx1Other Failure(4096)
		± An Excessive Error Rate
		(EER) has been detected
		on the network interface.

7112-A2-GB20-20 March 1998 C-15