Messages and Troubleshooting
8-2 7112-A2-GB20-20
March 1998

To configure SNMP Traps, follow this menu selection sequence:

Main Menu
→
Configuration
→
Load Configuration From
→
SNMP
→
SNMP Traps

Refer to Table A-10, SNMP Traps Options.

Device Messages

The Device Messages in Table 8-1, listed in alphabetical order, may appear in the

messages area at the bottom of the ATI screens.

Table 8-1. Device Messages (1 of 2)

Device Message What Message Indicates What To Do

Cannot Save – no
Login IDs with Access
Level 1
All of the login IDs being
saved have an access level
below Level 1.
Change the access level of at
least one Login ID to Level 1 so
that configuration changes can
be made. (Levels 2 and 3 cannot
make configuration changes.)
Save the Login IDs.
Command Complete Action requested has
successfully completed. No action needed.
Invalid Character (
x
)1A nonprintable ASCII
character has been
entered.
Re-enter information using valid
characters.
Invalid – Data
Terminal (or Channel)
Initiated Loopback
Active
Network-initiated loopback
was in progress when
another selection was
made.
No action needed.
Invalid Password Login is required and an
incorrect password was
entered; access is denied.
Try again.
Contact your system
administrator to verify your
password.
Invalid – [Test]
Already Active The [test] was already in
progress when another
selection was made.
Allow test to continue.
Select another test.
Stop the test.
Invalid Test
Combination A loopback or pattern test
was in progress when Start
was selected to start
another test, or was active
on the same or another
interface when Start was
selected.
Wait until other test ends and
message clears.
Abort all tests from the Test
menu screen.
Stop the test from the same
screen the test was started
from.
1
x
is the character not being accepted.