Paradyne 7112 manual Remote Send Line Loopback, Test Patterns for the Network

Testing

Remote Send Line Loopback

Remote Send Line Loopback sends the line loopback up or down code on the network interface for 10 seconds.

"Procedure

To run a Send Remote Line loopback:

1.Position the cursor at the Up or Down selection next to Send Line Loopback on the Network Tests screen.

2.Press the space bar to select either Up or Down.

3.Position the cursor at the Send command next to Up or Down selection and press Enter.

The Send command is changed to Sending. The loopback will stop automatically after 10 seconds. You cannot stop the Remote Send Line Loopback test manually.

Remote Send Line Loopback cannot be started when any other loopback or a

Send Pattern test is already active on the network interface.

Test Patterns for the Network

The Send test sends a QRSS or 1-in-8 test pattern over the network interface.

The Monitor test monitors the QRSS test pattern over the network interface.

"Procedure

To run a Send pattern test:

1.Position the cursor at the QRSS or 1-in-8 selection next to Send on the Network Tests screen.

2.Press the space bar to select the desired test pattern (QRSS or 1-in-8).

3.Position the cursor at the Start command next to the selected pattern and press Enter.

The Start command is changed to Stop.

4.To manually stop the test, verify that the cursor is positioned at the Stop command and press Enter.

7-6 March 1998 7112-A2-GB20-20