Paradyne CPX-1000 manual Module Troubleshooting, Remote failure indication line

4. Troubleshooting 1000-A2-GN22-00

Table 4–2. Telco Status Indicators (Continued)

Symptom	Possible Cause	Further Isolation of Alarm
MAJOR	PSTN	Remote failure indication - line
indicator on		Bit Error Ratio - signal fail or degraded
(continued)		Remove failure indication - STS path\
		Alarm indication signal - VT
		Loss of pointer or unequipped VT
		Payload label mismatch - VT
	T1 Ports	PSTN Alarm indication signal - DS1
		PSTN Remote Alarm indication - DS1
MINOR	IAD	Provisioned compression scheme(s) not supported
indicator on
	Table 4–3lists the modules and indicator states for normal
	operating conditions.
Table 4–3. Normal Activity Indicator Usage

Module

ATM CP/HSC EC ECAC

MP

T1

STS-1

Normal Usage

Active ATM modules have ACTive lit; standby module lights not lit Active CP/HSC module have ACTive lit; standby module lights not lit All unlocked EC modules are lit

All unlocked ECAC modules are lit

ACTive always lit

All unlocked T1 modules are lit

Active STS-1 modules have ACTive lit; standby module lights not lit

Module Troubleshooting

Before performing a module fault isolation:

1.Verify that the board and each component is securely seated.

Warning

Take care not to damage or bend the connector pins, and avoid touching areas of integrated circuits.

4-6 February 2003