Paradyne CPX-1000 manual STS-1 Module, Port T1 Ecac Module Controls, Indicators, and Ports

1000-A2-GN22-00 2. CPX-1000 Voice Services Platform Description

Table 2–6. 12-port T1 ECAC Module Controls, Indicators, and Ports

Cards	Controls, Indicators, and Ports	Function
12-port T1 ECAC	STAT	Lights green when processor is active
	ACT	Lights green if module is in active
		group
	T1 Port Indicators (12)	Lights red if carrier fails, or no carrier
		is present on the indicated port
	Hot Swap
12-port T1 Transition	RJ-21X PORT for 12 T1s	For T1 cable to Class 5 switch
	10 BT ETH RJ-48C port	Unused
	BITS RJ-48C port	For onsite BITS clocking source
	PCM TEST RJ-48C port	Unused
	RS-232	Unused

STS-1 Module	The STS-1 module consists of two cards (Figure 2–14) that supports
	one STS-1 interface containing 672 DS0s (28 DS1s) in a single
	physical interface. This interface may be connected directly to the
	Class 5 Switch, or it may be routed through an external STS-1 mux
	before being connected to the switch.
	STS-1 Processing Card—processor that controls the 28
	￿DS1s within an STS-1 circuit.
	STS-1 Transition Card—provides the STS-1 interface via
	Tx and Rx coaxial connections, plus a BITS timing interface.
	The STS-1 card features on-board echo cancellation. If compression
	is required, an Echo Cancellation and Compression card may be
	added. Debug interfaces are also provided.
	The STS-1 module increases the traffic capacity of the CPX over
	what can otherwise be obtained by using T1 modules. When
	configured for redundancy (1 + 1), these modules occupy shelf
	slots 11-16 in pairs.

February 2003 2-25