Paradyne CPX-1000 manual Installing, Additional Cards

3. Installing the CPX-1000 1000-A2-GN22-00

Installing	To install cards that are not yet installed in the CPX:
Additional Cards
Step 1	Put on an antistatic wrist strap, and plug the other end of that strap
	into the ESD ground jack in front (or back) of the CPX shelf.
Step 2	Slide each module into the cage slot until its ejector handles engage
	the retention bars at the top and bottom of the CPX.

Step 3	Tighten the top and bottom screws of the module using a Phillips
	screwdriver to secure it in place.
Step 4	Install the inter-module cables, where required.

3-22 February 2003