Paradyne manual Provision the CPX-1000, Verify CPX LAN, Connection

1000-A2-GN22-003. Installing the CPX-1000

	In most cases, you should change the IP address of the CPX to one
	that can be detected by the network management software on your
	LAN. After you change the IP address, the CPX requires rebooting.
	To change its default IP address, refer to the JetVision User’s Guide.
Verify CPX LAN	Validate the cable connections to the CPX Ethernet LAN port by
Connection	conducting a ping test:
Step 1	Verify that the MP Transition card is connected to the LAN hub or
	router, using a straight-through cable.
Step 2	Ping the CPX from a PC on the same LAN as the CPX.
Step 3	At the MP Transition card, verify that the Ethernet green (LINK)
	indicator is lit and the amber (ACTivity) indicator blinks rapidly
	during the test. (to indicates that the card is receiving and
	responding to the ping query data packets.)

Provision the CPX-1000

Refer to the JetCraft User’s Guide while using JetCraft to perform the following tasks:

Configure the CPX modules and ports

Check the CP module redundancy and learn to perform an administrative switchover

Check the ATM redundancy and learn to perform an ATM administrative switchover

Learn to reboot the MP and CP modules

Provision GR-303 Interface Groups

￿Provision Protection Groups

February 2003 3-35