Paradyne CPX-1000 manual Check Plug-in Module Indicators

1000-A2-GN22-00 3. Installing the CPX-1000

Check Plug-in

Module

Indicators

Step 1

Step 2

Step 3

After applying power, wait at least five minutes for the CPX to initialize. Then, check the indicators on the modules to verify that the modules are powered as described in the sections that follow.

If the indicator states are incorrect on any module, refer to the Service manual for corrective action.

Call Processor (CP) Indicator: Verify that the BFL indicator is not lit. The CPU, CPCI and PCI and ETH indicators light with activity.

Hot Swap Card (HSC) Indicator: Verify that the PWR indicator is lit to indicate that the CP and HSC cards are powered, and the ERROR indicator is off.

Management Processor (MP) Indicators: Verify that the PWR indicator is lit, and the Link indicator is lit to show that a communication link is established with the CP card. The ACT indicator lights when the module is in use.

Step 4	ATM Module OC-3 Indicators: Verify that the STATUS
	indicator blinks to indicate heartbeat is present. (STATUS lights
	solid when there is a problem). The Tx and Rx indicators will light
	when data transmission and reception occurs.
Step 5	Octal T1 Module: Verify that the green RUN indicator is lit, and
	the FAIL indicator is off. Each port indicator light should be off.
	They light when carrier fails, or no carrier is present. The blue Hot
	Swap indicator should also be off. The Power indicator on the
	corresponding transition card should be lit.
Step 6	12-port T1 ECAC Module: Verify that the green RUN indicator
	is lit, and the FAIL indicator is off. Each port indicator light should
	be off. They light when carrier fails, or no carrier is present. The
	blue Hot Swap indicator should also be off. The Power indicator on
	the corresponding transition card should be lit.
Step 7	STS-1 Module Indicators: Verify that the STAT and ACT
	indicators are lit, and TX and RX light green during data
	transmission/reception. The Hot Swap indicator should be out.
Step 8	STS-1 ECAC Module Indicators: Verify that the STAT and ACT
	indicators are lit, and TX and RX light green during data
	transmission/reception. The Hot Swap indicator should be out.

February 2003 3-33