Paradyne CPX-1000 manual Hot Swapping CP and HSC Cards, Hot Swapping Line Cards

1000-A2-GN22-00 5. Repair Procedures

Hot Swapping

CP and HSC

Cards

HSC cards are paired with CP cards. When you hot swap the CP-A card, you also need to swap the HSC-A card. After the HSC card is replaced, pairing with the CP card is automatically restored.

To hot swap CP and HSC cards, refer to JetVision User’s Guide and:

Step 1	Click the CP card icon in the Tree or Shelf view.
	To hot swap an active CP or HSC card, go to Step 2.
	￿To hot swap a standby CP or HSC card, go to Step 3.
Step 2	Perform switchover to place the active card in standby.
Step 3	Place the CP card in the Locked state.
Step 4	Select Configuration > Remove Resources. A prompt displays,
	confirming you want to remove the card resources.
Step 5	Click Yes. The card is removed from the Tree and Shelf views.
Step 6	Remove the CP card, followed by its corresponding HSC card (see
	Removing and Replacing Cards on page 5-9).
Step 7	Insert the HSC card, then insert the CP card, and lock them in place
	using the card ejectors (see Removing and Replacing Cards on
	page 5-9). (Continue with Step 9 if this is a standby CP or HSC
	card.)
Step 8	Select File > Refresh CPX. The new cards appear in the Tree and
	Shelf views.

Step 9

Hot Swapping Line Cards

Place the CP card in the Unlocked state.

When you hot swap a line card, you also need to swap its corresponding transition card.

Line cards include:

ATM OC-3 Module

Octal T1 and 12-port T1 ECAC

EC and ECAC

￿STS-1 and STS-1 ECAC

February 2003 5-11