Paradyne CPX-1000 manual Attach the T-1/ DS-1 Cables, Attaching Cables to Octal T1 Modules

3. Installing the CPX-1000 1000-A2-GN22-00

Attach the T-1/ DS-1 Cables

Attaching Cables to Octal T1 Modules

The CPX connects to host Class 5 switches via multiple T1/DS-1 spans. Each T-1 module in the CPX includes a corresponding T1 transition module that is accessible from the rear of the shelf.

Connect the host switch T1 cables to the CPX:

	Note
	T1 cables for the Octal T1 module require RJ-48C plugs
	on the CPX end for these connections. To facilitate the
	connections, label each cable by its destination port at
	the host Class 5 switch.
Step 1	Following the installation engineering and provisioning
	documentation, map the T1/DS-1 connections from the host switch
	to T1/DS-1 groups.
	Each T1 connection is assigned a T1/DS-1 group number and an
	individual connection number, such as 1-1. T-1 #1 must connect to
	T1/DS-1 #1 at the Class 5 switch, etc. A T1/DS-1 interface group is
	the logical administrator of the T1s. The minimum number
	required for an interface group is 2.
Step 2	Connect the T1/DS-1 spans to the T-1 transition modules in the
	back of the CPX shelf.

Note

T1 jacks are numbered 1–8 or 1–12 (#1 is located at the bottom).

3-26 February 2003