Pitney Bowes manual DA500/DA550 Basics Setting Up a Job

DA500/DA550 Basics • 3

Setting Up A Job (continued)

2. Input Area

Where you stack material for printing. You'll make most setup adjustments in this general area.

3. Interface Panel (Not Shown)

Located on the lower part of the rear cover, the panel has the ON/OFF switch, parallel cable connector and power cord receptacle.

4. Wire Frame

Supports the material stack. Adjust the feed angle to accommodate the weight of the material you're running. Adjust its side-to-side position so it's centered under the stack.

5. Feed Ramp and Lock Knob

The feed ramp adds a gentle slope to the stack to help feeding. Lower the feed ramp until the top of the bottom piece in the stack reaches the middle of the feed ram. Secure the feed ramp with the lock knob.

6. Wireframe Slide

Slides the wireframe side to side. Lock in position with the lock lever (Item 7).

7.Wireframe Slide Lock Lever (Not Shown) Locks the wireframe slide in position.

8.Feed Fence

Helps confine the stack. Adjust to the width of your material plus 1/16" clearance.

Pitney Bowes DA500/DA550 Operator Guide 3-5