DA500/DA550 Basics • 3
Setting Up A Job (continued)
3. Set the Feed Angle
The feed angle of the wireframe input stacker depends on the type of material you're running:
• Heavy material: | adjust to a low angle. |
•Standard material: adjust to the center (45 degree Angle).
•Light material: adjust to a high angle. To make the adjustment:
1.Loosen the lock knob on the wireframe slide.
2.Move the wireframe up or down as required.
3.Tighten the lock knob to secure the wireframe.
Wire Frame
Lock Knob
Pitney Bowes DA500/DA550 Operator Guide |
