Pitney Bowes DA500, DA550 manual Feed Ramp

3 • DA500/DA550 Basics

Setting Up A Job (continued)

6.Adjust the Position of the Feed Ramp With a stack of material loaded:

1.Loosen the lock knob that holds the feed ramp in position.

2.Lower the feed ramp until the top of the bottom piece of the stack reaches the middle of the feed ramp.

3.Tighten the feed ramp's lock knob to hold it in position.

Feed Ramp

At this point, it's a good idea to recheck your setup ad- justments:

•Is the separator gap adjustment correct?

•Is the wireframe centered under the material?

•Is the feed angle okay?

•Is there a slight clearance between the sliding fence and the edge of the stack?

3-14 Pitney Bowes DA500/DA550 Operator Guide