Printronix MVP Series user manual Host Mode Control Code Sequence Format, ESC Ps q where

Host Mode Control Code Sequence Format

P–Series

The P–Series (Configuration Option 20.1) control code sequence format is:

(Valid Header); [Ps q		where:
Valid Header	=	first character (header) of a mode change control code
		sequence. One of 11 hexadecimal characters can be
		recognized as a valid header in accordance with
		Configuration Option 31 through 41 defined in Table 7–7 .
[	=	an ASCII “left bracket” (5BH)
Ps	=	New Mode to be entered, where:
		Ps = 31H, for Mode 1
		Ps = 32H, for Mode 2
		Ps = 33H, for Mode 3
		Ps = 34H, for Mode 4
		Ps = 35H, for Mode 5
q	=	Control Code Sequence Terminator = 71 hex

NOTE: Do not use any spaces in the host mode control code sequence.

ANSI

The ANSI–compatible operation (Configuration Option 20.2) requires the following Control Code sequence:

ESC [Ps q where:

ESC	=	ASCII “Escape” (1BH)
[Ps q	=	the same as P–Series definitions

NOTE: Do not use any spaces in the ANSI host mode control code

sequence.

7–22 Programming