RAD Data comm Vmux-2100 Voice Trunking Gateway operation manual Configuring the Main Link

Vmux-2100Installation and Operation Manual Chapter 4 Management from a Terminal

Configure the timeslots of each E1/T1 port (voice or data, mapping to specific bundles, routing to remote ports and timeslots).

Configuring the Main Link

The main link module of Vmux-2100 may include 10/100BaseT port and E1/T1 port.

Configuring the Ethernet Port

The Ethernet port of the Vmux-2100 main link module supports autonegotiation. If the autonegotiation is disabled, the Ethernet port can be configured to operate in 10BaseT (half duplex or full duplex) or 100BaseT (half duplex or full duplex) mode.

To configure the Ethernet port:

1.From the Configuration menu (see Figure 4-4), choose Card. The Card menu appears (see Figure 4-21).

Card

1.Main board

2.Slot 1

3.Slot 2

@ - Db Update; # - Db Undo ESC-prev.menu; !-main menu; &-exit

Figure 4-21. Card Menu

2. From the Card menu, choose Main board.

The Main Board menu appears (see Figure 4-22).

Main Board

1.Lan Parameters

2.E1 Parameters

@ - Db Update; # - Db Undo ESC-prev.menu; !-main menu; &-exit

Figure 4-22. Main Board Menu

3.From the Main Board menu, choose Lan Parameters. The Lan Parameters menu appears (see Figure 4-23).

Configuring Main Link and Voice E1/T1 Ports 4-19