Chapter 4 Management from a TerminalVmux-2100Installation and Operation Manual
Note | When operating | |
delays are minimal, you can configure | ||
| ||
| packets more frequently to ensure the early notification of a main link failure. In IP | |
| networks, where delays are more common, it is recommended to set the | |
| connectivity parameters to their maximum values. | |
|
| |
| TOS Parameters (standard Type of Service parameters of the outgoing IP | |
| frames): | |
| Precedence (Routine, Priority, Immediate, Flash, Flash Override, | |
| Critic/Ecp, Internetwork Control, Network Control) | |
| Delay (Normal, Low) | |
| Throughput (Normal, High) | |
| Reliability (Normal, High). | |
| Voice Parameters (see Figure |
Voice Parameters
1.Coder/Rate (kbps) (G.723.1/6.4)
2.Fax/Modem
3.MF Relay (enable)
4.Minimum Pulse Width (milliseconds)[30 - 32676]... (80)
5.Minimum Power Level (negative dBm)[0 - 35]... (0)
@ - Db Update; # - Db Undo
Figure 4-35. Voice Parameters Menu
Coder/Rate (compression algorithm and corresponding rate): G.723.1/6.4 (as per G.723.1 requirements at 6.4 kbps) G.723.1/5.3 (as per G.723.1 requirements at 5.3 kbps) G.729A/8 (as per G.729 A requirements at 8 kbps)
G.711 a LAW (as per G.711 requirements,
G711 u LAW (as per G.711 requirements,
Fax/Modem (enable/disable fax or modem signal identification and relay, and define the it transmission rate in kbps): 4.8, 9.6, 14.4.
MF Relay (enable/disable MF tone identification and relay).
The two following parameters (Minimum Pulse Width and Minimum Power Level) appear only when the MF relay is enabled.
Minimum Pulse Width (minimum pulse width of the MF tone to be detected and relayed): 30 to 32676 msec.
Minimum Power Level (minimum power level of the MF tone to be detected and relayed): 0 to
