RAD Data comm Vmux-2100 operation manual Configuring E1/T1 Groups and Bundles, Configuring a Group

Chapter 4 Management from a Terminal Vmux-2100Installation and Operation Manual

266–399 Feet

399–533 Feet

533–655 Feet.

Next, the timeslots that are to carry user data are assigned by choosing Time Slot Table From the T1 Parameters menu (as described for the E1 links)

Time Slot Table
	Ts#	1	2	3	4	5	6	7	8	9	10	11	12
		Yes	Yes	Yes	No	No	No	No	No	No	No	No	No
	Ts#	13	14	15	16	17	18	19	20	21	22	23	24
		No	No	No	No	Yes	No	No	No	No	No	No	No
1.	No
2.	Yes

@ - Db Update; # - Db Undo ESC-prev.menu; !-main menu; &-exit

Figure 4-28. Time Slot Table (for T1 Link)

From the Time Slot Table, toggle between timeslots by pressing <Tab>, and assign the timeslot(s) that are to carry data by entering Yes. To disconnect a timeslot, enter No.

Note Since Vmux-2100 uses only one T1 main link at a time, the timeslot mapping is applicable also for the inactive T1 port.

Configuring E1/T1 Groups and Bundles

Each pair of external E1/T1 ports of the Vmux-2100 voice module is referred to as a group. Vmux-2100 supports up to eight E1/T1 groups.

Configuring a Group

You have to assign an IP address to each E1/T1 group.

To assign an IP address to a group:

1.From the Card menu, select a slot, to which belong a group you want to configure by choosing the corresponding number.

The Slot menu appears (see Figure 4-29).

4-24 Configuring Main Link and Voice E1/T1 Ports