RAD Data comm Vmux-2100 Voice Trunking Gateway operation manual Appendix C Configuration Menus

Appendix C

Configuration Menus

This appendix lists all menus of the Vmux-2100 management software.

Main menu

1.Inventory 2. Configuration

1.System 2. Hub

1. Management					1.	Main Board
					2.	Slot 1
	1.	Host IP			3.	Slot 2
					4.	Slot 3
					5.	Slot 4
			1.	Set Host IP Address
			2.	Set Subnet Mask
			3.	Set Default Gateway
			4.	Trap
			5.	Read
			6.	Write
	2.	Manager List
	3.	Host Mux Name
	4.	User Administration
			1.	Add New User
			2.	Delete User
			3.	Change User Details
			4.	Show All Users

5. Signaling Configuration

1.Signaling Profile Configuration

2.SS7 Keep-Alive Suppression Rate

6. Telnet

2. Control Port

1. Set Baud Rate

2. Timeout

3. Dial-In Modem

3. Date & Time Update

4. Factory Default

5. Show Partition Information

6. Set the Active Application

7. Reset Card

8. Open Internal Alarms

3. Card
	1. Main Board
		1. LAN Parameters
				1. Set Auto Negotiation
				2. Set Capability
			2. E1 Parameters					2. T1 Parameters
					1.		Connect		1.	Connect
					2.		Frame
					3.		Restoration Time		2.	Clock Source
					4.		Clock Source		3.	Frame
					5.		Interface Type		4.	Interface Type
					6.		Idle Code		5.	Line Code
									6.	Rx Sensitivity (CSU only) 6. Line Length (DSU only)
				3. Time Slot Table					7.	Tx Gain Level (CSU only)
									8.	Restoration Time
									9.	Idle Code
	2. Slot 1
		1. Group 1
				1. IP Address
				2. Bundles Parameters
				1. Display Bundles
				2. Bundle Configuration
						1. Add Bundle
						2. Delete Bundle
						3. Edit Bundle

1. Enter Bundle Number

2.Connect

3.Function

4.Max Bytes in Multiplexed Frame

5.Destination IP

6.Destination Bundle

7.Packetizing Interval

8.Connectivuty Parameters

9.TOS Parameters

10.Voice Parameters

1.Coder/Rate

2.Fax/Modem

3.MF Relay

4.Minimum Pulse Width

5.Minimum Power Level

11.VLAN Parameters

12.Bundle Name

3. External 1
	1. E1		Parameters	2. T1 Parameters
		1.	Connect	1.	Connect
		2.	Frame	2.	Clock Source
		3.	Interface Type	3.	Frame
		4.	Restoration Time	4.	Interface Type
		5.	Clock Source	5.	Line Code
		6.	Idle Code	6.	Rx Sensitivity (CSU only) 6. Line Length (DSU only)
		7.	Signaling	7.	Tx Gain Level (CSU only)
		8.	Profile	8.	Restoration Time
				9.	Idle Code
	2. Distribution of Framer			10. Signaling
		Time Slots		11. Profile
		1. Display Time Slots
		2. Time Slots Configuration

1. Update from Time Slot

2.To Time Slot

3.Type

4.Bundle

5.Destination Port ID

6.Destination Time Slot ID

7.Update Time Slot

Figure C-1. Inventory and Configuration Menus

C-1