Vmux-2100Installation and Operation Manual

Appendix B Boot Manager and Software Downloading

 

 

 

 

 

 

 

 

 

B.3 Downloading the Application and Configuration

Software

New application software releases are distributed as *.img files, which are downloaded to Vmux-2100 using the XMODEM protocol from the File System menu of the boot software. Alternatively, you can download a new software release via TFTP protocol, when the Vmux-2100 management software is already running.

The TFTP protocol can also be used for uploading configuration files which contain the Vmux-2100 database to the management station. Administrators can use this capability to distribute verified configuration files to all other units which use the similar configuration.

Downloading Application Files via XMODEM

Downloading application files using the XMODEM protocol is performed from the File System menu of the boot software.

To download application file via XMODEM:

1.Configure your ASCII terminal or terminal emulation utility running on your PC to the 115.2 kbps data rate.

2.Access the File System menu (see the Accessing the File System section above). The File System menu appears (see Figure B-1).

3.From the File System menu, type 4.

Vmux-2100 displays the following message:

Select partition to download

4. Select the backup partition by typing its number, 1. Vmux-2100 requires confirmation of the partition deletion:

The partition is full. Do you want to erase it (y/n)

5. Type Y.

Vmux-2100 responds with the following string:

Please start the XMODEM download.

6.Send the *.img file to Vmux-2100 using the XMODEM utility of you terminal application.

Once the downloading is completed, Vmux-2100 saves the new release as an active partition, the former active partition turns into backup, and the boot sequence continues normally.

If a failure occurs during the download, the partially downloaded software is erased. In this case, only active software is left in the Flash memory.

Note After the software upgrade has been performed, it will take several minutes for the Vmux-2100 to begin operating again. This delay is due to the time the main module requires to update all the voice modules.

Downloading the Application and Configuration Software

B-3

Page 115
Image 115
RAD Data comm Vmux-2100 Voice Trunking Gateway operation manual Downloading the Application and Configuration Software