GUIDE TO COMPONENTS |
|
|
| ||
1. | Platen | Cover | Lower | this cover | over an original before print- |
|
|
| ing. |
|
|
2* | Front | Door | Open | for access | to the inside of the machine. |
3.Side Plate Fine Use to shift the paper feed table sideways.
Adjusting Dial
4.Paper Feed Table Press to lower the paper feed table.
Down key or
Change Paper key When you have an optional large capacity tray, this key is used to remove paper.
5.Paper Feed Side Use to prevent paper skew.
Plates
6.Paper Feed Table Set paper on this table for printing.
7.Separation Roller Use to adjust the separation roller pressure to
Pressure Levers prevent double feed.
8.Feed RollerUse to adjust the contact pressure of the pa-
Pressure Lever | per feed roller according to paper thickness. |
9.Original TableUse to open the original table unit when install-
Release Lever | ing the master. |
10.Original Holder Convenient place for holding originals while op-
erating the machine.
11.Operation Panel Operator controls and indicators are located here. = See page 6.
12.Behind CoverOpen to access the CS Mode key and so on.
=See page 6.
2
