Roland V-Synth owner manual Rhodes Multi, Keyboard Multi, 135

36: Rhodes Multi

Enhancer, Phaser, Chorus or Flanger, and Tremolo or Auto-pan are

connected in series. This effect is used for electric piano.

fig.MFX-36
L
Enhancer	Phaser
R

			Tremolo/
	Chorus/
	Flanger		Auto Pan
Parameter	Value	Description
Enhan Sw	OFF, ON	Turns the enhancer effect on/
		off.
Enhan Sens	0–127	Sensitivity of the enhancer
Enhan Frequen-	0–127	Sets the lower limit of the fre-
cy		quencies to which the enhance-
		ment effect is added.
Enhan Mix Lev-	0–127	Level of the overtones generated
el		by the enhancer
Enhan Level	0–127	Volume of the enhancer sound
Phaser Manual	0–127	Specifies the center frequency at
		which the sound is modulated.
Phaser Rate	0.05–10.0 Hz,	Specifies the frequency of mod-
	note	ulation.
Phaser Depth	0–127	Specifies the depth of modula-
		tion.
Phaser Reso-	0–127	Specifies the amount of feed-
nance		back for the phaser.
		Higher settings will give the
		sound a stronger character.
Phaser Mix Lev-	0–127	Specifies the volume of the
el		phase-shifted sound, relative to
		the direct sound.
Mod Mode	CHORUS,	Selects whether to use chorus or
	FLANGER	flanger.
Mod Rate	0.05–10.0 Hz,	Adjusts the speed of modulation
	note	for the chorus or flanger.
Mod Depth	0–127	Adjusts the depth of modulation
		for the chorus or flanger.
Mod Phase	0–180 deg	Sets how the chorus or flanger
		sound is spread.
Mod Pre Delay	0–50.0 ms	Adjusts the delay time from the
		direct sound until the chorus or
		flanger sound is heard.
Mod Feedback	-98– +98 %	Adjusts the proportion of the ef-
		fect sound that is fed back into
		the effect. Negative (-) settings
		will invert the phase.
Mod XoverLPF	500–15000 Hz,	Adjusts the cutoff frequency of
	THRU	the low pass filter. (THRU: no
		filter is used)
Mod XoverHPF	THRU, 50–800	Adjusts the cutoff frequency of
	Hz	the high pass filter. (THRU: no
		filter is used)
Mod Level	0–127	Volume of the chorus or flanger
		sound.

		Effects List
Parameter	Value	Description
Trem/Pan Sw	OFF, ON	Turns the tremolo/auto pan ef-
		fect on/off.
Trem Mode	TREMOLO,	Selects whether to use tremolo
	AUTO PAN	or auto pan.
Trem Wave-	TRI, SAWUP,	Selects the type of modulation.
form	SAWDN, SQR,	TRI: Triangle wave
	SIN	SAWUP/SAWDN: Sawtooth
		Wave
		SQR: Square wave
		SIN: Sine wave
	SAWUP	SAWDN
Trem Rate	0.05–10.0 Hz,	Frequency of modulation
	note
Trem Depth	0–127	Depth of modulation

37: Keyboard Multi

A ring modulator, 3-band equalizer, pitch shifter, phaser, and delay are connected in series.

Ring Modulator is an effect which applies ring modulation using an internal oscillator to the input signal, producing bell-like sounds.

fig.MFX-37

L	Ring	3-Band	Pitch
R	Modulator	EQ	Shifter

Phaser Delay

Parameter	Value	Description
Ring Freq	0–127	Frequency at which modulation
		will be applied
Ring Balance #1	DRY100:0WET–	Volume balance between the di-
	DRY0:100WET	rect sound (DRY) and the ring
		modulated sound (WET)
EQ Low Freq	50–4000 Hz	Frequency of the low range
EQ Low Gain	-15– +15 dB	Gain of the low range
EQ Mid Freq	50–20000 Hz	Frequency of the middle range
EQ Mid Q	0.5, 0.7, 1.0, 2.0,	Gain of the middle range
	4.0, 8.0	Set a higher value for Q to nar-	Appendices
		row the range to be affected.
EQ Mid Gain	-15– +15 dB	Gain of the middle range
EQ Hi Freq	2000–20000 Hz	Frequency of the high range
EQ Hi Gain	-15– +15 dB	Gain of the high range
PS Grade	1–5	Sets the grade of the effect
		sound.
		The higher the value is set, the
		more natural-sounding can be
		obtained; however, this increas-
		es the delay from the source
		sound as well.

135