Roland V-Synth Part1-16 Rx Sw Part 1-16 Receive Switch, Patch Tx Ch Patch Transmit Channel

Settings Common to All Modes (System Mode)

Part MIDI	Controller Settings (Controller)
fig.05-04_50	Tx
	fig.05-05_50

Part1–16 Rx Sw (Part 1–16 Receive Switch)
For each part, specify whether MIDI messages will be received (ON),
	Patch Tx Ch (Patch Transmit Channel)
or not (OFF).
If this is “ON,” you can play that part from an external MIDI device.	Specifies the transmit channel of MIDI messages in Patch mode. If
Normally, you will select “ON” only for part 1 which you play from	you do not want to transmit MIDI messages to external MIDI
the keyboard.	devices, turn this parameter “OFF.” If you want the transmit channel
Value: OFF, ON	to always match the Patch Receive Channel, set this parameter to
Part 1–16 Rx Ch (Part 1–16 Receive Channel)	“RX CH.”
	Value: 1–16, RX CH, OFF
Specifies the MIDI receive channel for each part.	Tx PC (Transmit Program Change Switch)
Value: 1–16
	Specifies whether Program Change messages will be transmitted
Performance data directed to the V-Synth itself will be	(ON) or not (OFF).
	Value: OFF, ON
transmitted on the channel you specified for part 1.
	Tx Bank (Transmit Bank Select Switch)
	Specifies whether Bank Select messages will be transmitted (ON) or
	not (OFF).
	Value: OFF, ON
	Tx Active Sens (Transmit Active Sensing
	Switch)
	Specifies whether Active Sensing messages will be transmitted (ON)
	or not (OFF).
	Value: OFF, ON

Settings Common to All Modes (System Mode)

77