Roland V-Synth owner manual Pedal, Beam

Settings Common to All Modes (System Mode)

Knob 1, 2 Assign		Pedal
Specifies the MIDI controller number that will be transmitted by		fig.05-09_50
movements in the ASSIGNABLE CONTROL knob.
Value
OFF: No message will be transmitted.
CC01–31,33–95:Controller numbers 1–31, 33–95
	For more information about Control Change messages, please
	refer to “MIDI Implementation” (p. 153).
Beam
fig.05-08_50
		Hold Polarity (Hold Pedal Polarity)
		Select the polarity of the Hold pedal. On some pedals, the electrical
		signal output by the pedal when it is pressed or released is the
		opposite of other pedals. If your pedal has an effect opposite of what
		you expect, set this parameter to “REVERSE.” If you are using a
		Roland pedal (that has no polarity switch), set this parameter to
		“STANDARD.”
		Value: STANDARD, REVERSE
		Pedal 1, 2 Assign
D Beam Sens L, R (D Beam Sensitivity L, R)		This specifies the function of each pedal connected to the CTRL 1,
		CTLR 2 PEDAL jacks.
This sets the D Beam Controller’s sensitivity. Sens L is the left side.		Value
The higher the value set, the more readily the D Beam Controller		OFF: The control pedal will not be used.
goes into effect. Normally you will leave this at “100.”
		CC01–31,33–95:Controller numbers 1–31, 33–95
Value: 0–200
D Beam 1–4 Assign L, R			For more information about Control Change messages, please
Specifies the MIDI controller number that will be transmitted by			refer to “MIDI Implementation” (p. 153).
		BEND UP: Pitch bend (positive direction)
movements in the D Beam Controller. Assign L is the left side, and
		BEND DOWN: Pitch bend (negative direction)
Assign R is the right side.
		AFT: Aftertouch
Value
OFF: No message will be transmitted.		Pedal 1, 2 Polarity
CC01–31,33–95:Controller numbers 1–31, 33–95		Selects the polarity of the pedal. On some pedals, the electrical signal
	For more information about Control Change messages, please	output by the pedal when it is pressed or released is the opposite of
		other pedals. If your pedal has an effect opposite of what you expect,
	refer to “MIDI Implementation” (p. 153).
		set this parameter to “REVERSE.” If you are using a Roland pedal
		(that has no polarity switch), set this parameter to “STANDARD.”
		Value: STANDARD, REVERSE

Settings Common to All Modes (System Mode)

79